A1:

In an undisclosed in-house test, silky 3 minute mode electrolysis was repeated with mineral water (Evian, water temperature 25°C), and the following results were obtained.

1st time = 930ppb (0.93ppm)
2nd time = 1059ppb (1.059ppm)
3rd time = 1161ppb (1.161ppm)

A2:

There is an electrode plate (+ on the top and + on the bottom when two sheets are stacked) on the bottom of the silky board, and press the power button 3 times to electrolyze for 3 minutes.
This is the same as electrolysis performed in science experiments in junior high school, which is decomposed into hydrogen and oxygen.
At that time, you can see bubbles in the water.
After production, the amount of hydrogen will be about half in 1-2 hours, and will completely disappear in 5-6 hours, so you can take more hydrogen if produced immediately before drinking.

A3:

Press the generate button 3 times for the 3-minute mode, and press the generate button twice for the 1-minute mode, both at a good tempo and early.
It does not work when pressed four times.
Also, if you press the generate button after the blue lamp is on, it will be canceled and it will turn out.

A4:

The dissolved hydrogen concentration determination reagent cannot determine the hydrogen concentration of silky.
Use the dissolved hydrogen meter (hydrogen concentration meter) to measure the concentration of hydrogen water generated by Silky.

※The judgment reagent originally measures the redox potential.
   when water is electrolyzed with GymSilky, hydrogen, oxygen, and some ozone are generated.
   Therefore, even if a reagent is added, it will first react with oxidizing substances (oxygen and ozone), and the reagent will not be transparent.
   Reagents that have once reacted with ozone will not return to their original state even if hydrogen is added later.

A5:

The cartridge contains ceramic to make the water taste good.
It is generally said that the effect of ceramics is to oscillate energy from the ceramics to the molecules of water to make the water mellow (activation) and to make the water delicious.
In addition, the white one inside the cartridge has a role of reducing chlorine odor with calcium.
White object may mix in water when hot water is added to silky water, it is calcium and does not harm the body.

A6:

Cartridge: 2 liters of hydrogen water is produced every day for about 2 years, but if it smells like chlorine, replace it. The replacement time of the cartridge depends on the chlorine concentration and water temperature.

Battery: The battery has less than half the charging performance when the battery is fully charged more than 500 times from the state of zero power, and the number of continuous use becomes shorter. The new 3 minutes mode was possible 10 times in a row, but now it will be a few times. It is recommended that you charge the rechargeable battery frequently so that it will not be discharged, as it will extend its life.

Electrode plate: Life is about 10 years in normal use, but if platinum on the surface is not scratched, the production capacity will decrease by about 30%. Clean with citric acid for maintenance. For details, please see "How to care for Silky" on the website.

A7:

Clean the inside of Silky for hygiene purposes.
Clean the inside of Silky for hygiene purposes.
For details on how to clean, see "Cleaning Silky" below.

※Please see herefor how to care for silky.

A8:

We recommend tap water or mineral water.
Pure water and RO water are less likely to electrolyze, and hydrogen generation is extremely reduced.
Also, do not put tea, coffee, juice, etc. in the silky.